|
- Simple crystal oscillator simulation in LTspice
I'm attaching an LTspice file that simulates a crystal oscillator with resonant frequency 1MHz, and it works fine But if I change L1 from 2 5 H to 9 8 mH to simulate a crystal oscillator with resonant frequency 16MHz, it flat-lines (no oscillations) If I replace the CMOS inverter with a custom
- LTspice Simulating a VCO oscillator - Electronics Forum (Circuits . . .
I have been trying to simulate a VCO for a CB radio on LTspice, but cannot get it to run The ac analysis give me a peak at about 3 5 MHz but cannot get anything from the trans It is supposed to oscillate at 17 55 MHz and is basically a LC circuit connected to Pins 1 and 2 of the chip
- How to simulate UART in MPLAB X IDE? - Electronics Forum (Circuits . . .
Hi, I wrote UART code that sends UART data to the PC I want to simulate it and therefore need to see a terminal that will present the data being sent to the PC from the PIC during the simulation How can I open up a terminal during the simulation? Thanks!
- Using the IDE simulator (Oshonsoft). | Electronics Forum (Circuits . . .
We’re opening this special thread dedicated to sharing fully simulatable examples using the OshonSoft IDE, perfect for those who program in PIC Basic as well as for those who prefer working directly in assembler The goal is to gather practices and projects that can be run entirely within the IDE’s built-in simulator, making the most of its powerful tools like the oscilloscope, virtual
- simulation of NTC thermistor with LT spice | Electronics Forum . . .
Hello I make a simple simulation of a dc current source applied on a 10 Kohms thermistor When I perform a transient simulation (I1 = 10 mA until 10 s) , the thermistor warms up and reaches a steady state value When I make a DC sweep with current as sweep source (from O to 30 mA), the
- Latching-relay (single and dual-coil) simulation models
In connection with this other thread, I developed LTspice simulation models respectively for single and dual-coil DPDT latching relays, based on data from
- Circuit Simulation and Modeling a Motor using a Resistor
You cannot simulate a motor or a globe Both take a very high current at the beginning and the driving device plus the power supply must be able to deliver this current
- Pspice to LTspice igbt model - Electronics Forum (Circuits, Projects . . .
What about if I want to simulate the IXYS model IXGT32N170A? How to get the subckt inputs on it?
|
|
|