|
- Loading a small boat into truck bed - Tacoma World
I'd put an end of it onto a furniture dolly Then lift the other end up and onto the tailgate Grab the other end off the dolly and lift push into the truck You'll also need an extender from the hitch to support the portion of the boat that is not sitting on the bed tailgate Overall looks a lot easier than loading a 500lb motorcycle
- Bed Light Wiring Advice? (SOLVED) - Tacoma World
Hi everyone and Merry Christmas! I installed my "factory" bed lights and I'm running into a problem - they won't light up! I ran out of daylight so
- Bed Mount Bolt Torque Spec? - Tacoma World
Just got a torque wrench from my girlfriend for my birthday, and figured I'd straighten out my slightly misaligned bed Tried searching and couldn't
- Tacoma Loose Bed design Flaw explanation
Second Gen Tacomas that go off road, fetch heavy loads or have campers with heavy racks can suffer from the loose bed issue The symptom will be a
- Bed Removal? - Tacoma World
6 bed bolts, remove gas cap (4 bolts), remove tail lights, bed electrical outlet, tailgate and camera There are a few clips you must remove off the bed by the tail lamps
- Bed rail drilling help - Tacoma World
Bed rail drilling help Discussion in ' 3rd Gen Tacomas (2016-2023) ' started by Jimmy Minnesota, Mar 13, 2024
- Tacoma Bed removal
Thanks everyone for the bed removal help, I started the removal and the four bolts toward the cab were fairly easy, but the two in the rear were nut and bolts which I had to cut with a grainder ,due to the notorious RUST With that said I purchased all new hardware from Toyota to replace all nuts ,bolts and washers Thanks again everyone
- Bed Replacement - Tacoma World
A metal bed will not peel off when sliding in steel with sharp edges, but it adds weight and most of the time I'm pretty close to loaded max A plastic bed melts when cutting steel or throwing hot scrap in it, and I have concerns about how it will hold up at 40 below zero but it is nice and light giving me more payload
|
|
|